Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
omv7:armbian_bookworm_install [2024/02/07 02:48] – [Not Supported] crashtest | omv7:armbian_bookworm_install [2024/04/11 02:24] – [Finishing the Armbian Install] crashtest | ||
---|---|---|---|
Line 1: | Line 1: | ||
{{indexmenu_n> | {{indexmenu_n> | ||
- | ====== Installing OMV7 on Armbian Bookworm | + | < |
+ | Remark: Given the similar setup, this doc contains numerous reused screen shots from the OMV7-Armbian Bulleye doc. | ||
+ | ---></ | ||
+ | |||
+ | < | ||
{{ : | {{ : | ||
\\ | \\ | ||
- | \\ | + | ====== Installing OMV7 on Armbian Bookworm ====== |
- | + | ||
- | + | ||
\\ | \\ | ||
\\ | \\ | ||
+ | |||
Line 52: | Line 54: | ||
* **Bookworm** images **with desktops** are **not** supported. | * **Bookworm** images **with desktops** are **not** supported. | ||
* **Jammy**, **Trixie** and other non-Bookworm variants are **not** supported. | * **Jammy**, **Trixie** and other non-Bookworm variants are **not** supported. | ||
- | * Images at the bottom of some device pages under the heading of " | + | * Images at the bottom of some device pages under the heading of " |
- | * Images | + | * **Bookworm** images |
+ | (These images are built nightly - usually the date will be the current day or the day before.) | ||
\\ | \\ | ||
- | {{ : | + | {{ : |
---- | ---- | ||
===== Prerequisites ===== | ===== Prerequisites ===== | ||
Line 271: | Line 274: | ||
< | < | ||
+ | \\ | ||
< | < | ||
- | After logging in with the default password, you'll be required to change the root password. | + | \\ |
- | Follow the prompts to enter and confirm a new root password. (Remember this password.) | + | < |
+ | < | ||
{{ :: | {{ :: | ||
---- | ---- | ||
Line 281: | Line 286: | ||
< | < | ||
\\ | \\ | ||
- | * The shell to be used: Beginners should use **bash**. | + | * **Create default system command |
- | * The creation of a non-root user, with “sudo” admin abilities: User's choice. '' | + | * **Create a new user account**: |
{{ :: | {{ :: | ||
Line 295: | Line 300: | ||
- | On the command line, copy and paste the following | + | On the command line, copy and paste the following |
'' | '' | ||
- | |||
- | When the command prompt returns copy and paste the following command into the SSH window: | ||
'' | '' | ||
- | (This process with take a few to several minutes.) | + | (The above command may take a few to several minutes |
+ | |||
+ | '' | ||
Finally, reboot the SBC with the following command: | Finally, reboot the SBC with the following command: | ||
- | '' | + | '' |
\\ | \\ | ||
**Note:**\\ | **Note:**\\ |