Differences

This shows you the differences between two versions of the page.

--- omv7:omv7_plugins:wireguard [2024/03/08 04:41] – [Management of a Custom Config] chente
+++ omv7:omv7_plugins:wireguard [2024/04/24 15:28] (current) – [Configuring a Client] chente
@@ Line 1: / Line 1: @@
+{{indexmenu_n>8}}
 \\
 <html><center><b>Wireguard Plugin For OMV7</b></center></html>
@@ Line 147: / Line 148: @@
   * Click **Save**. At this point, if you have already activated the tunnel and the client, the connection will be up and running.
   * By pressing the button **Client Config** you can see the client configuration file, you can copy and paste the text in a file to configure the connection in the client. If you do it this way, add the ending ".conf" to the created file. Treat this file like a password, it is the access key to your network. Once the connection is configured, it is advisable to delete this file for security.
-  * A QR will appear in the table (if the client is enabled), which you can scan from a smartphone to configure the connection without having to copy a file. If you need to send it you can take a photo. Treat this image as a password, it is the access key to your network.
+  * A QR will appear in the table (if the client is enabled), which you can scan from a smartphone to configure the connection without having to copy a file. If you need to send it you can take a photo. Treat this image as a password, it is the access key to your network (the first time the page loads after setup the QR code still does not appear, please reload the page or change tabs and come back to see the QR code).
   * Use a different client configuration for each client. If you configure the same connection on several clients at the same time, they will not be able to connect simultaneously.
@@ Line 200: / Line 201: @@
   * In the **Config** field write the configuration content of your tunnel following the Wireguard rules.
     * You can see how to do it on the [[https://www.wireguard.com/#simple-network-interface|Wireguard]] website. Or use a template following the suggestion at the bottom of this section.
+    * If you want to connect to a commercial VPN service, they will most likely provide you with the tunnel configuration template. In that case, simply copy and paste that template into the Config field.
     * If you need special topologies you can find them on the [[https://www.procustodibus.com/blog/2020/10/wireguard-topologies/|procustodibus.com]] website.
     * Note that the networks created by the plugin in the **Tunnel** and **Client** tabs are generated in the ''10.192.x.x'' network range. Therefore, choosing networks in this range may cause conflicts. In that case the service will not start and the plugin will throw an error.