Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
omv6:new_user_guide [2023/05/10 22:22] – [Quick Start Guide for Advanced Users:] crashtest | omv6:new_user_guide [2023/11/11 19:33] (current) – Remove selective updates comment ryecoaaron | ||
---|---|---|---|
Line 10: | Line 10: | ||
\\ | \\ | ||
\\ | \\ | ||
- | < | + | < |
\\ | \\ | ||
\\ | \\ | ||
Line 20: | Line 20: | ||
December 12th, 2022 - Rev 1.0 Links to the Utilities and Maintenance doc, updated links, various minor revisions and edits. Removed 3rd party translation links.\\ | December 12th, 2022 - Rev 1.0 Links to the Utilities and Maintenance doc, updated links, various minor revisions and edits. Removed 3rd party translation links.\\ | ||
January 26th, 2023 - Rev 1.1 Updated multiple screen shots to reflect changes in the top menu of the GUI.\\ | January 26th, 2023 - Rev 1.1 Updated multiple screen shots to reflect changes in the top menu of the GUI.\\ | ||
+ | May 10th, 2023 - Rev 1.2 Note on OMV-Extras config, various minor formatting changes.\\ | ||
{{ : | {{ : | ||
Line 842: | Line 843: | ||
\\ | \\ | ||
< | < | ||
+ | \\ | ||
{{ : | {{ : | ||
\\ | \\ | ||
Line 854: | Line 856: | ||
resources would eliminate excess E-mails, while maintaining **Storage reports** on hard | resources would eliminate excess E-mails, while maintaining **Storage reports** on hard | ||
drive health and file system errors.\\ | drive health and file system errors.\\ | ||
+ | \\ | ||
{{ : | {{ : | ||
\\ | \\ | ||
Line 887: | Line 890: | ||
\\ | \\ | ||
**Domain name:** \\ | **Domain name:** \\ | ||
- | The default is fine. If needed, the Domain suffix can be changed here. (Very few users will use Fully Qualified Domain Names.) | + | The default is fine. If needed, the Domain suffix can be changed here. (Very few users will use Fully Qualified Domain Names.) |
+ | \\ | ||
{{ : | {{ : | ||
\\ | \\ | ||
Line 895: | Line 899: | ||
Part of the SBC installation process was setting the wired interface to DHCP. SBC | Part of the SBC installation process was setting the wired interface to DHCP. SBC | ||
- | users should consider leaving their wired network interface set to DHCP, until [[https:// | + | users should consider leaving their wired network interface set to DHCP, until [[https:// |
If a static IP address is needed: \\ | If a static IP address is needed: \\ | ||
Line 911: | Line 915: | ||
click the **Edit** button. | click the **Edit** button. | ||
\\ | \\ | ||
- | (The interface name may not be the traditional Linux eth0. A variety of different | + | < |
- | names may be found, such as **eno1** or others.) \\ | + | < |
+ | \\ | ||
{{ : | {{ : | ||
\\ | \\ | ||
---- | ---- | ||
\\ | \\ | ||
- | * The following is an example only. If users are unsure of the entries needed for | + | < |
- | the following screen, leave **IPv4** set to **DHCP** and skip **Network**, **Interfaces** settings. | + | < |
{{ : | {{ : | ||
\\ | \\ | ||
Line 980: | Line 986: | ||
When the **Install** button is clicked, all applicable upgrades will be installed. | When the **Install** button is clicked, all applicable upgrades will be installed. | ||
(Recommended for beginners.) \\ | (Recommended for beginners.) \\ | ||
- | ** *Note* ** that it is possible to “selectively” upgrade by highlighting a single | ||
- | package and clicking the **Install** button. | ||
{{ : | {{ : | ||
\\ | \\ | ||
Line 1087: | Line 1091: | ||
\\ | \\ | ||
(**Optional**) \\ | (**Optional**) \\ | ||
- | Under **System**, **OMV-Extras**, | + | Under **System**, **OMV-Extras**, |
In **Settings**, | In **Settings**, | ||
\\ | \\ |