Differences

This shows you the differences between two versions of the page.

--- omv8:raspberry_pi_install [2026/09/13 19:56] – [Installing OMV8 on a Raspberry PI] crashtest
+++ omv8:raspberry_pi_install [2026/09/14 02:50] (current) – [Installing OMV8 on a Raspberry PI] crashtest
@@ Line 15: / Line 15: @@
 Draft: 22 Dec 2025\\
-Revisions: 13 Sep 2026 - Added "sudo" at the beginning of wget script retrieval command lines.\\
+Revisions: 13 Sep 2026\\
+- Added "sudo" at the beginning of wget script retrieval command lines.\\
+- R-PI imager clarifications.\\
 ===== Introduction =====
@@ Line 244: / Line 245: @@
 ----
 \\
-<html><center>Under Storage, select the mounted SD-card</b></center></html>
+<html><center>Under <b>Storage</b>, select the mounted SD-card</center></html>
 {{ :omv8:omv8-rpi-imager-4.jpg?nolink&600 |}}
@@ Line 252: / Line 253: @@
 ----
 \\
-<html><center>Under Customisation, enter the hostname desired - users' choice.</b></center></html>
+<html><center>Under <b>Customisation</b>, <b>Customisation: Hostname</b>, enter the hostname desired - users' choice.</b></center></html>
 {{ :omv8:omv8-rpi-imager-5.jpg?nolink&600 |}}
@@ Line 268: / Line 269: @@
 ----
 \\
-<html><center>Under <b>Customisation</b>, <b>Customisation: Choose username</b>, create a <b>username</b> and <b>password</b>.</center></html>
+<html><center>Under <b>Customisation</b>, <b>Customisation: User</b>, create a <b>username</b> and <b>password</b>.</center></html>
 <html><center>The username and password entered here will be the administrative user that will be utilized in later operations on the command line.</center></html>
@@ Line 278: / Line 279: @@
 ----
 \\
-<html><center>Under <b>Customisation</b>, <b>Customisation: Choose Wi-Fi</b>, <b>DO NOT</b> change these entries.</center></html>
+<html><center>Under <b>Customisation</b>, <b>Customisation: Wi-Fi</b>, <b>DO NOT</b> change these entries.</center></html>
 <html><center>If Wi-Fi is needed, it will be configured later in the OMV8 GUI.</center></html>
@@ Line 287: / Line 288: @@
 ----
 \\
-<html><center>Under <b>Customisation</b>, <b>Customisation: SSH authentication</b>,</center></html>
+<html><center>Under <b>Customisation</b>, <b>Customisation: Remote Access</b>,</center></html>
 <html><center><b>Enable SSH</b> and select <b>Use password authentication</b>.</center></html>